Toro Workman 3000 Series, Service Manual

Page: 261 / 306

Front Wheel
Drive (4WD)
NOTE: Remove bearing cones (29) from the differen-
tial case only if they need replacing (see Inspection).
Retain shims (31) for reassembly of new bearing cones.
10.Remove bearing cone (29) from the differential case
(27) with a puller.
Make sure puller is inserted into the
indentations on the differential case (Fig. 20).
IMPORTANT: Make sure shims (21) are kept after
they are removed from the carrier assembly (15).
11. Pull pinion gear shaft (8) and bearing cone (9) from
the carrier assembly (15). If necessary, press pinion
gear shaft out of the carrier housing. Remove oil seal
(20) and discard it. Remove bearing cone (22), shims
(21), and spacer (24) from the carrier housing(15) (Fig.
21).
NOTE: Remove bearing cone (9) from the pinion gear
shaft (8) only if it needs replacing (see Inspection).
12.Press pinion gear shaft (8) out of the bearing cone (9)
using bearing press.
Make sure shaft does not drop
to the floor (Fig. 22).
NOTE: Remove bearing cup (23) from the carrier hous-
ing (15) only if it needs replacing (see Inspection).
13.Press bearing cup (23) from the carrier assembly
(15) (Fig. 23).
Figure 20
Figure 21
Figure 22
Figure 23
Workman 4000 Series Page 10 – 19 Front Wheel Drive (4WD)