Toro Workman 3000 Series, Service Manual

Page: 101 / 306

24.Disassemble reduction shaft assembly:
A. Use a bearing puller to remove bearing (Item 1)
from reduction shaft.
B. Remove gear (Item 2), helical gear (Item 3), collar
(Item 4) and gear (Item 5).
C. Use a bearing puller to remove bearing (Item 6).
D. Remove washer (Item 7), needle bearing (Item 9)
and gear (Item 8).
E. Remove spacer (Item 10).
F. Remove snap ring (Item 11).
G. Remove shifter (Item 12) together with spring,
hub and 3 keys.
Figure 45
1
3
5
15 14 13
10
7
18
2
4
17
16
12
11
9
8
6
H. Remove key (Item 13).
I. Remove synchro ring (Item 14) from gear (Item
15).
J. Remove gear (Item 15), needle bearing (Item 16)
and thrust washer (Item 17). Inspect needle bearing
and replace if necessary. Measure thickness of
thrust washer. Replace thrust washer if thickness is
less than .0709 in. (1.8 mm).
1
2
3
4
5
18
13
17
16
15
14
12
11
8
9
7
6
Figure 46
Drive T
rain
Workman 3000/4000 Series Page 6 – 29 Drive Train