InchMode Controller (T3: TEC) (optional) (continued)
T3: TEC Outputs
OUTPUT NUMBER
DESCRIPTION
OUT 1
Not Used
OUT 2
Not Used
OUT 3
Not Used
The machine electrical schematic and wire harness drawings in
can be used to identify possible circuit problems between the
controller and the input or output devices.
IMPORTANT
When testing for wire harness continuity at the connector for
the controller, take care to not damage the connector pins with
multimeter test leads. If connector pins are enlarged or damaged
during testing, connector repair may be necessary for proper
machine operation.
g259387
Figure 84
1.
InchMode wire harness connector P01
2.
InchMode controller (T3: TEC)
A 20 pin InchMode wire harness connector is attached to the controller. The
connection terminal function for the controller and the wire harness connector
pins are shown above.
Because of the solid state circuitry built into the controller, there is no method to
test the controller directly. A controller may be damaged if an attempt is made to
test it with an electrical test device (e.g. digital multimeter or test light).
Note:
The InfoCenter Display, TECs, and the TDM used on the Outcross 9060
machine are matched for correct machine operation. If any of these components
are replaced for any reason, system software needs to be reloaded (contact an
Authorized Toro Distributor for assistance).
Electrical System: Electrical Component Testing
Page 6–26
Outcross 9060
18234SL Rev B
Summary of Contents for 07511AA
