Tokyo Keiki TG-8000 Series, Operator'S Manual

Page: 33 / 105

3
－
1
CHAPTER 3 OPERATING METHOD
WARNING
●
There are matters to be attended in starting of this system and operations during
running. These matters are described in each related item in this chapter with
CAUTION or WARNING, etc., which should always be observed.
●
Read the Operator's Manual of the automatic steering system carefully preparing for
occurrence of trouble or alert in this system, and the emergency steering method should
be well understood to treat such matters smoothly.
3.1 General
In this chapter, procedure of operation, start and stop of this system are explained.
Before operation, confirm that each unit of the master compass and the control unit are
properly installed.
For the automatic steering system, read carefully the related Operator's Manual in
separate volume supplied by the manufacturer, and perform appropriate preparation and
handling before its operations.
3.2 Operating panel
For position and details of the operating panel, read explanation of this chapter referring
to Figure 7.1 and Figure 7.2 attached in the end of this manual.
Also for the cases of the automatic steering system built-in type and the console built-in
type, confirm the operating panel position by referring to the finished plan of the ship.
3.2.1 Explanation of the operating panel
①
Power switch / Power indicator
It is used to start or stop this system.
By pushing this switch after opened the cover, it starts.
After started, close the cover not to push inadvertently.
②
DISP switch
It is used to select the indicated item and the indicated data.
By pushing this switch, data is indicated in order.
By pushing this switch with pressing ACK/ENT switch
④
, data is indicated in
reverse order.
For the indicated data, refer to explanation of data indicator
⑧
and mode indicator
⑨
.
③
SET switch
It is used to change data and to change the input system.
Data can be changed for the following items.
Gyrocompass true heading / ship's speed / latitude / rate of turn
Input system can be changed for the following indicated items.
*1
Ship's speed (MANUAL, GNSS, LOG and LOG (serial signal))
Latitude (GYRO and GNSS)