Tokyo Keiki TG-8000 Series, Operator'S Manual

Page: 42 / 105

3
－
10
3. Indication automatically moves to departure date and time indication.
SET. time
4. Set the departure date and time by pushing △ or ▽ switch
⑤
and determine
them by pushing ACK/ENT switch
④
.
Note: When the current date and time does not reach the previously set
departure date and time, the previously set departure date and time is
displayed in the above data indicator.
5. Indication automatically moves to start heading setting. Set the start heading.
Refer to "3.4.1 Start (3) Setting of start heading" in this chapter.
6. The set departure date and time are displayed for 3 seconds after the start
heading setting. Then, all indications are extinguished except the power switch
①
and the timer is started.
Note: This system will start as automatically finishing last azimuth operation and
turning to the set heading 4 hours before the set date and time.
(3) Setting of start heading.
After Software version number is indicated for the case without timer start function,
or after departure date and time is indicated for the case with timer start function,
the indicator becomes “start heading input” indication as shown below.
Initial heading
1. Set the start heading by pushing △ or ▽ switch
⑤
.
2. Determine the entered value by pushing ACK/ENT switch
④
.
3. The indicator indicates the gyrocompass true heading and the master compass
turns to the entered heading.
Note: When the system starts from the heading when the last azimuth
operation completed, setting of "the start heading" is not necessary.
However, push ACK / ENT switch
④
.
If ACK/ENT switch
④
is not pushed, this system automatically
proceeds to the next sequence after 3 minutes.
Data indicator
Mode indicator
Data indicator
Mode indicator