Tokyo Keiki TG-8000 Series, Operator'S Manual

Page: 44 / 105

3
－
12
2. After pushed SET switch
③
, select either "GNSS" or "GYRO" by pushing
△
or ▽ switch
⑤
.
Every pushing of △ or ▽ switch
⑤
caused blinking display of the following two
kinds of data alternately as shown below.
・
Input system: GYRO
・
Input system: GNSS
3. Determine it by pushing ACK/ENT switch
④
.
4. When "GYRO" was selected, as the latitude is displayed in the data indicator, set
the latitude by pushing △ or ▽ switch
⑤
and push again ACK/ENT switch
④
.
Hereafter calculated latitude by ship's speed and true heading is indicated.
(5) Synchronization of the repeater compass
*1
After the last azimuth operation completed, the repeater signal and the serial signal
are outputted. Turn "OFF" each repeater switch and adjust it to the gyrocompass
true heading, then turn "ON" the repeater switch.
(6) Settling time
The time to "settled" requires approx. 6 hours maximum although it depends upon
the starting condition.
*1:
When repeater is a serial signal type, this operation is not required because it will
synchronize automatically, however, confirm that the indicated value coincides with "the true
heading" selected by this system after the repeater switch turned "ON".