Tokyo Keiki TG-8000 Series, Operator'S Manual

Page: 35 / 105

3
－
3
⑩
Alert indicator
Alert status is displayed. When an alert is generated, it goes blinking.
After ACK/ENT switch
④
is pushed, it is still lit if alert state is continued and goes
off if alert state was restored.
⑪
System select indicator
Selected system is displayed.
3.2.2 Indication
(1) True heading 1 : The true heading of the sensor selected as system, either the
gyrocompass true heading or the external heading sensor true
heading, is displayed.
For the system selection, refer to "3.4.2 System Selection" in this
chapter.
The indicated data in the data and mode indicators are shown below depending
upon the system selection.
Note:
・
Only shaded areas are indicated for one gyrocompass system.
・
The meaning of a display of a
“mode indicator” is the following.
S.S.G = Steering Sensor. Gyrocompass
S.S.E = Steering Sensor. External sensor
Gyt = Gyrocompass true heading
・
When GNSS communication abnormality, LOG (serial signal) communication
abnormality or LOG (contact) abnormality is generated, the data indicator is
blinking.
At this time, if "GYRO" system is selected, operate according to "3.4.5 (2)
Countermeasures when GNSS communication abnormality is generated", "3.4.5
(4) Countermeasures when LOG (serial signal) communication abnormality is
D a t a i n d i c a t o r M o d e i n d i c a t o rD a t a i n d i c a t o r M o d e i n d i c a t o r
N O . 1 G Y R O
1 2 3 . 4 1 2 3 . 4 2 3 4 . 5
N O . 2 G Y R O
2 3 4 . 5 1 2 3 . 4 2 3 4 . 5
E x t e r n a l
H e a d i n g
3 4 5 . 6 3 4 5 . 6 3 4 5 . 6
S y s t e m
s e l e c t i o n
H e a d i n g
N O . 1 G Y R O i n d i c a t i o n
N O ． 2 G Y R O i n d i c a t i o n