TI120 Series Variable Frequency Drive
Detailed parameter introduction
- 132 -
prevent the variable frequency drive from reporting an overcurrent fault effectively.
P60.12
Current limiting level
range:20.0%~200.0%
Factory
default:160.0%
The current limit level setting value is a percentage relative to the rated current of the variable
frequency drive.
P60.13
Slip compensation gain
range:0.0%~300.0%
Factory
default:100.0%
When the load increases, it causes the motor speed to decrease. By setting an appropriate slip
compensation gain value, it helps to maintain the motor speed stable under load fluctuation or heavy
load.
P61 Encoder Parameters
P61.00
Speed feedback encoder
selection
range:0~2
Factory default:0
0: incremental encoder 1
1: incremental encoder 2
2: sine encoder
Select the type of motor speed feedback encoder.
P61.01
Encoder 1 resolution
range:0~10000
Factory default:1024
When PG vector control is selected, the resolution of the motor speed feedback encoder must be
set correctly, otherwise the motor cannot run normally.
P61.02
Electrical angle offset 1
range:0.00°~359.99°
Factory
default:0.00°
P61.03
Encoder 1 signal phase
range:0~1
Factory default:0
0: normal
Phase A is ahead of phase B during forward rotation.
1: reverse
Phase B is ahead of phase A during forward rotation.
P61.04
The numerator of the
electronic gear ratio 1
range:1~65535
Factory default:1000
P61.05
Denominator of electronic gear
ratio 1
range:1~65535
Factory default:1000
P61.06
Encoder 2 resolution
range:0~10000
Factory default:1024
P61.07
Electrical angle offset 2
range:0.00°~359.99°
Factory
default:0.00°
P61.08
Encoder 2 signal phase
range:0~1
Factory default:0
P61.09
The numerator of the
electronic gear ratio 2
range:1~65535
Factory default:1000
P61.10
Denominator of electronic gear
ratio 2
range:1~65535
Factory default:1000
For the parameter setting of encoder 2, refer to the setting of encoder 1.
