Theta Digital Casablanca III, Owner'S Manual

Page: 12 / 130

IMPORTANT NOTICE
I.
Due to the computer-based circuitry used in Theta products, it is imperative that the Casablanca III
be connected to a ground via its three wire AC power cord. It is important that the AC power outlet,
which the Casablanca III is plugged into, is actually grounded. Failure to do so will severely
compromise the performance, reliability and safety of use of the Casablanca III.
II.
It is also important to prevent contact with static electricity when connecting other components and
cables to the Casablanca III. When connecting cables, simply place one hand on top of the
Casablanca III and then grasp the metal “barrel” of the cable with the other hand and plug (unplug)
the cable into (from) the appropriate jack on the Casablanca III.
III.
The Casablanca III, as with all electronic equipment, is susceptible to static discharges. Resetting
the unit may be required if anomalies occur after receiving a static discharge. In this case, put the
unit in standby and turn off the rear panel power switch for 2 minutes, and then turn it on again.
IV.
Ventilation is an important issue when placing the Casablanca III in a system. Make certain that the
Casablanca III is placed in a well-ventilated area or rack unit.
V.
Please take note that some powerline conditioners defeat the AC power ground on their outlets. If
the intention is to plug the Casablanca III into a line conditioner, check with your dealer to make
certain that the particular conditioner that is intended for use DOES NOT DEFEAT THE AC
GROUND on its AC outlets.
VI.
DO NOT remove any cover panels from the Casablanca III, as there are no user serviceable
components inside. Refer servicing and updating to qualified service personnel only.
VII.
Should the Casablanca III need to be reset, it must be put in standby first via the front panel power
button. Then the rear panel power switch is to be turned off for at least 2 minutes.
VIII.
The Casablanca III can be susceptible to excessive RF. End caps in all unused inputs will improve
the sound quality and may reduce the susceptibility to RF induced anomalies.
Reference Manual Conventions
For clarity purposes, references to buttons, LED’s and display parameters will be shown in bold capital
letters.
All functions to be performed from, and in reference to the front panel of the Casablanca III will be found in
the front section of this manual, whereas all functions to be performed using the hand held remote and/or
viewed on a video monitor will be found in the back, or last part of this manual.
2