Thermo Scientific ThermoFlex10000, Installation, Operation And Maintenance Manual

Page: 133 / 210

Section 4
ThermoFlex 4-11
Thermo Scientific
Figure 4-7
Setup Loop (Optional Features)
Continued on next page.
xx
xxx
xx
xx
FLt
indC
xx
di t
SEc
HZ
ALr
di t
FiLL
LoFLO
HiFLO
HiFLO
enter
enter
enter
enter
enter
enter
enter
enter
enter
OPT
HZ
CArE
•
HZ
is used to identify the incoming frequency for
chiller's with P 3 - P 5 pumps and the capability to run
on either 50 Hz or 60 Hz. The selected frequency
automatically adjusts the firmware's fixed high pressure
default setting.
Range: 50 Hz or 60 Hz Default: 60 Hz
• OPt
is used to configure the analog in/out mode of
operation. See Appendix C.
• FiLL is used to set the time limit the auto refill has for
filling the reservoir to the normal operating level.
Range: 0 to 900 seconds
Default: 45 seconds ThermoFlex900 - 5000
80 seconds ThermoFlex7500 - 24000
Exceeding the time limit flashes rEFiL and the auto refill
will shut off. The chiller's reaction depends on the alarm
ALr setting, Flt is shut down, indC is continue to run.
Note Setting the time limit to 0 disables the auto refill
option.

See Section 5 for additional information.
•
di t
is used to set the preventive care cleaning frequency
reminder for the chiller's DI filter cartridge.
Range: 0 to 9999 hours Default: 448 hours
Exceeding the limit flashes
di
, see Section 6.
• HiFLO is used to set the high flow alarm limit.
Exceeding a high limit flashes HiFLO
and, if enabled,
sounds the alarm. The chiller's reaction depends on the
alarm ( ALr ) setting.
Note
This feature is not enabled until the value is
changed to something other than 0.0.

Shaded displays only appear
on chillers equipped with that option.
T 0 T 1 Range: 0.0 to 10.5 GPM Default: 0.0 GPM
T 5 Pump Range: 0.0 to 15.0 GPM Default: 0.0 GPM
P 1 Pump
Range:
0.0 to 10.5 GPM
Default:
0.0 GPM
P 2 Pump Range: 0.0 to 10.5 GPM Default: 0.0 GPM
P 3 Pump Range: 0.0 to 30.0 GPM Default: 0.0 GPM
P 4 Pump Range: 0.0 to 30.0 GPM Default: 0.0 GPM
P 5 Pump Range: 0.0 to 30.0 GPM Default: 0.0 GPM
T 9 Pump Range: 0.0 to 33.5 GPM
Default:
33.5 GPM