Thermo Scientific Heracell Vios 160i CR, Operating Instructions Manual

Page: 69 / 216

4
Start-up
Installing the HEPA Filter in the Rear Panel
Thermo Scientific
Heracell Vios 160i / 250i CR
4-9
Installing the HEPA Filter in the Rear Panel
The HEPA filter (2/ Figure 4-5 ) must be inserted into the airbox (1/ Figure 4-5 ) from below. The airbox
rests on the water reservoir cover panel (2/ Figure 4-6 ) and is pushed against the air intake.
Installing the Shelf System
Figure 4-8. Support Rail Installation/Removal
Tools are not required for the installation of the shelf system. The support rails are secured using spring
pressure. After the shelf supports have been inserted into the rail, the shelves are pushed onto the shelf
supports.
Installation/Removal of the Support Rail
The support rails are guided and held in place by the embossings in the workspace floor and ceiling.
The locksprings of the support rails must point upwards (see
Figure 4-8 on page 4-9 ).
1. Position the support rail onto the lower embossing and tilt it toward the workspace side wall so
that the rail is positioned over the two embossings.