Thermo Scientific Heracell Vios 160i CR, Operating Instructions Manual

Page: 62 / 216

4
Start-up
Installing the “MAX” Fill Level Indicator and the Prefilter
4-2
Heracell Vios 160i / 250i CR
Thermo Scientific
• Shelf support
• Prefilter
• Air duct
• Airbox
• Shelves
• Workspace surfaces
• Glass door seal
• Glass door/gas-tight screen.
Installing the “MAX” Fill Level Indicator and the Prefilter
The “MAX” fill level indicator and the prefilter can be installed without any need for tools:
1. Make sure that the tube is removed from the fill and drain valve (3/ Figure 4-2 ).
2. Check whether the drain (2/ Figure 4-2 ) in the front section of the water reservoir is free of
obstruction; it is needed for discharging the water through the fill and drain valve (3/ Figure 4-2 )
on the front side of the unit.
3. Suspend the “MAX” fill level indicator (1/ Figure 4-1 ) in the slot provided in the water reservoir
cover panel (5/ Figure 4-1 ).
Note
Disinfection:

For details about the cleaning and disinfection of the device see chapter “Cleaning and
Disinfection” on page 8-1 .
CAUTION

Observe the instructions or technical data of the manuals delivered with the spare parts or
accessories. The instructions or technical data can differ from those stated in this manual.