Operating Instructions
50
The display briefly shows PROGRAMMING ZONE ON/OFF
- PLEASE WAIT (Figure 31). The display then confirms the
new Zone 2 setting for several seconds.
Figure 31: New Zone 2 Setting
The display then returns to the Standard Display showing Zone
2 is off. The setpoint for Zone 2 has been replaced with OFF as
shown in Figure 32 to indicate that the zone is now off.
Figure 32: Zone Off
Starting the Diesel Engine
Diesel engine preheating and starting is automatic in both
Continuous Mode and Cycle Sentry Mode. The engine will
preheat and start as required when the unit is turned on. If any
keys are being pressed on the HMI control panel prior to the
engine start, the engine preheat and start will be delayed until
10 seconds after the last key is pressed.
NOTE: If the unit is equipped with optional SmartPower
there may be some additional prompts before the engine will
start. See STARTING THE ELECTRIC MOTOR on the
following pages for details.
WARNING: Never use starting fluid.
When the engine is preparing to start the HMI control panel
will display the engine start screen, as shown in Figure 33. The
preheat buzzer sounds during the engine preheat and crank
sequence.
WARNING: The engine mat start automatically any
time the unit is turned on.
Summary of Contents for Precedent C-600M
