TERRY Melody 1, Installation Manual

Page: 9 / 66

Terry Melody 1 - Installation Instructions - ED01050g
9
NOTES
ref: ED01052c, dated: 19/08/2011
21. Fix charger box to wall. Plug in charger and replace cover
22. Bleed hydraulic system.
• Ensure the hydrualic hose is plugged into pump connector.
• SAFETY: cover the hydraulic fittings to avoid injury from high
pressure hydraulic fluid!
• Loosen the 1/4” BSP female Q-release carrier - 1/4” BSP male
female compact elbow joint.
• Operate pump and bleed from the loosened joint.
• Retighten loosened joint after bleeding.
23. Make suitable holes in the base of the bellows and secure to the front of
the base frame and ramp support plate with tie wraps. Note: On outside
installations before securing the bellows liberally spray all lift parts
enclosed by the bellows e.g base frame and scissor arms with the wax
oil provided.
24. Rivet the ‘serial number plate’ to the RH side of the power pack cover
using the existing holes.
25. Carry out final adjustment and test as per pages 13, 15, 16, 17 and 29