TERRY Melody 1, Installation Manual

Page: 13 / 66

Terry Melody 1 - Installation Instructions - ED01050g
13
ref: ED01057a, dated: 07/06/2006
MELODY 1 HEIGHT ADJUSTMENT
IMPORTANT:
Before adjusting the mechanism ensure anti-creep switch is disconnected
(refer to page 19)
The control mechanism will be pre-set to a platform height of 1000mm
With lift at ground level disconnect the spring
Stop lift at required height. Slacken bolts. Rotate adjustment disc (larger
diameter) until face A is in contact with roller of top limit switch (brown wires).
Re-tighten bolt
Lower lift to ground level and re-connect the spring. The spring must be
wound around 1 full turn before hooking onto tab on rear of disc. Check top
level height
BOWDEN CABLE ADJUSTMENT
Before setting the height the bowden cable must be adjusted to set the
position of the switch on the wheel that releases the lower gate. The lower
gate should only release when the lift is around 100mm off lower level
(usually nuts are to very end of thread closest to wheel).
Spring
Top Limit Switch (Brown wires)
Final Limit Switch Latch
Platform Gate
Enabler Switch
Face A
Inner Wheel
Final Limit
Switch
Adjustment disc
NOT TO BE USED IN
SETTING TOP HEIGHT
Fixing Bolt
Upper Gate
Enable Switch Anti Creep Switch
(Purple wires)
Cable Failure Switch
NOTES
Used to set gate
release for lower
level. Wind nut to
the end of the thread
on every install