TERRY Melody 1, Installation Manual, Page: 4 / 66

base
frame
platform
Fixing
holes
1345mm
440mm
Terry Melody 1 - Installation Instructions - ED01050g
4
ref: ED01052c, dated: 10/01/2012
MELODY 1 INSTALLATION INSTRUCTIONS
1. Manually raise platform / scissor arms and insert safety scotch through
holes in base frame (see diagram page 10).
2. Slide platform onto scissor arm
blocks (tall side up) and secure
in place with 6 X M6 counter-
sunk screw.
Note : These fasteners will be
located in the top of the scissor
arms when the lift is supplied
without the platform already
fitted.
3. Level platform using levelling bolts on base frame ensuring moving ramp
aligns flush with fixed ramp.
4. Remove the 4 X M6 CSK, 2 X M6 HEX/Washers located on the top face
of platform.
5. Position power pack assembly on platform, pump to ramp and secure
into place using bolts previously removed.
6. Feed the Hydraulic hose/ 6 Way connector and attached wiring for
charger box / 3 way connector and attached wiring for lower wall station
/ Bowden cable through the round hole in the base of the platform that is
located near the pump reservoir tank.
7. Engage end of Bowden cable through slot in control mechanism.
8. If necessary re-engage spring hook end onto control mechanism roll pin.
NOTES
This side must be either 150mm
away from any wall / obstruction
or less than 10mm
Must be at
least 150mm
away from
any wall
obstruction
Allow 10mm
(max) between
lift and rise