TERRY Melody 1, Installation Manual

Page: 32 / 66

Terry Melody 1 - Installation Instructions - ED01050g
32
ref: ED01066a, dated: 07/06/2006
MELODY 1 APPENDIX-REMOTE CONTROL ENABLER
SYSTEM
Operation
The single channel control system is comprised of a transmitter CE1038 and
receiver CE1037.The receiver is set in the 3 minute timer mode.
The receiver is powered by 12 volts dc and the controlled output is a N/O
contact.(The receiver is a black box inside the control box)
The remote radio control enabler is supplied factory set. If the lift has been
left in storage or disconnected from the mains for a long period it maybe
necessary to reprogram the receiver as per stages 1 and 2 below. When
programming a new key fob only stage 1 needs to be carried out.
Stage1-Reprogramming of key fobs
1) Use a ball pen and push the programming switch until the LED starts
fl ashing then release. It is now in programming transmitter’s mode.
2) Within 5 seconds, press the button on the fob and hold it pressed until the
LED is on continuously then release the button.
3) The receiver is now programmed to the transmitter frequency.
4) To check that the receiver is programmed to the transmitter, press
the transmitter button and the N/O contacts on the receiver should
momentarily go S/C
Stage2-Programming the output timer
1. Use a ball pen and push the programming switch until the LED starts
fl ashing then release and push the switch again until the LED fl ashes at a
slower rate. It is now in programming output timer mode.
2. To obtain the 3 minute timer function push the transmitter button four
times. It should now fl ash four times then pause.
3. To exit the programming output timer mode wait 15 seconds to allow the
system to automatically exit the mode.
LAYOUT OF CE 1037 RECEIVER
ANTENNA
BLACK / WHITE +
12 VOLTS DC
BLACK -
WHITE
N/O CONTACTS
GREY
PROGRAM SWITCH
LED
NOTES