TERRY Melody 1, Installation Manual

Page: 6 / 66

Terry Melody 1 - Installation Instructions - ED01050g
6
ref: ED01052c, dated: 10/01/2012
• Offer the lock assembly to the gate. Note:
orientate the lock assembly so that the lock is
located on the outer side of the gate.
• Run the gate wire neatly from the gate outlet,
through the holes in the lock mounting plates
and into the lock through the appropriate side.
• Fix the lock assembly in place using the 4
bolts, washers and nuts from the fixing kit.
14. Position opposite hand rail and kick strip
and refit the dome head screws/washers/
lockwashers at the two non-ramp and top ramp end fixing positions.
15. Lock fitting continued:
•Fit the lock beak bracket mounting plate
together with the lock beak and spacer plate
onto the appropriate handrail. The lock beak
mounting plate is secured using the pre-fitted
handrail cross tube bolts. Unscrew the bolts,
insert the mounting plate and re-fit bolts in
correct locations. DO NOT TIGHTEN.
•Close the gate and align the lock and lock
beak with each other using the adjustment
slots on each assembly. When alignment is
satisfactory, tighten all bolts.
• Wire the lock, matching the wire numbers with the terminal identifiers:
wire No. Terminal
1 21
2 22
3 Earth
4 M
• Fit the back cover using the 4 screws from the fixing kit.
• Fit the lock cover and secure with the screw
from the fixing kit. Insert the blanking bung into
the lock cover.
NOTES