Terrasat IBUC 2, Operation Manual

Page: 85 / 196

M&C Interfaces
|
5-3
Engineered to Endure
Thresholds for alarms that are user configurable can be set by using any of the M&C
interfaces described in this chapter.
To disable the multifunction LED use the ASCII command CLE on page C - 13 .
Ethernet
Using Ethernet, you can communicate with the IBUC
2
, IBUC
2e
, IBUC
2 G
,
IBUC
R
or IBUC
G
through SSHv2, SNMPv3 or through the onboard Web Server
(HTTPS). The IBUC uses a static IP addressing structure and does not support DHCP
(Dynamic Host Control Protocol).
The IBUC is configured at the factory, as follows:
IP Address 192.168.1.21
IP Gateway 192.168.1.1
Subnet Mask 255.255.255.0
Table 5.1
Default Alarm Configuration
Alarm State
Major Minor None
Tx Alarms
U
se
r
C
on
fig
ur
ab
le
So
lid
R
ED
Fl
as
hi
ng
R
ed
Lo
g
O
nl
y
DRO out of lock No X
Tx Output Level High Yes X
Tx Output Level Low Yes X
Tx Input Level High Yes X
Tx Input Level Low Yes X
High Temperature Alarm Yes X
Tx Simulated Fault No X
10 MHz Reference Fault No X
Input Voltage Out of Range No X
Switch Fault No X
Input Current Out of Range No X
AGC/ALC Target Out of Range No X
AGC/ALC Out of Range No X
Overdrive Alarm No X
Tx Muted Alarm No X