Terrasat IBUC 2, Operation Manual

Page: 119 / 196

Screen Shots
|
B-13
Engineered to Endure
• Tx Output
Select whether the unit is actively transmitting. Options include:
•
Enabled
•
Disabled
• Power Monitor Frequency
Sets the Power Monitor Frequency which is the actual frequency at which you are
operating. To ensure accurate readings, you must set your operating frequency
which might be different from the factory default values listed in Table B.1 .
Example : If the frequency allocated to you by the satellite carrier is 6400 MHz, set
the Power Monitor Frequency to 6400 MHz.
The factory default values in
Table B.1 are listed according to the model number
of the IBUC. For more information about identifying the model number of the
IBUC, see Appendix A, Part Numbering Schema .
• Tx State at Power-Up
Sets whether the unit is transmitting upon power-up. Options include:
•
Enable
•
Disable
• Tx Power-Up Delay
Sets the transmit power output delay of the IBUC in seconds. When configured,
the Tx Output will be muted for the period specified before beginning to transmit.
• Power Read Mode
Sets the mode in which power is read. Options include:
•
Burst
In burst mode, the input signal is active only a small percentage of the time
because packets of data are sent in bursts.
Table B.1
Default Values for Power Monitor Frequency
Model Number Default Value Model Number Default Value
050052 5100 128133 13050
057064 6075 137142 14000
058064 6137 137145 14125
058066 6250 140145 14250
058067 6287 173181 17700
064067 6575 181184 18250
067070 6875 290300 29500
079084 8150 295300 29750
127132 13000 300310 30500