Installation
Connectors
39
PRISM MPS Installation and Safety Instructions
SFP module
There are several types of optional SFP modules available for the MPS-200 and -300
products.
SFP Module Installation and Removal
1.
Remove the plug from the SFP connector.
2.
Insert the SFP module into the SFP connector. The module will latch into place
when fully inserted.
Note:
Different types of SFP modules may have different latching mechanisms.
To remove the optical SFP module, disengage the latch and then pull the module out of
the SFP connector.
SFP Module Transportation
CAUTION: To prevent static damage to the SFP module, if you remove the SFP
module from the instrument, always store and transport the SFP module in an
anti-static bag or container.
REF OUT
Note:
This is a dual purpose pin that can be controlled in the UI
to set to
REF OUT or
PPS
•
REF OUT is a pass through of the REF IN.
•
PPS connector outputs a 1 PPS (pulse per second) signal when
the instrument is locked to a PTP reference. 3.3v drive. TTL
compatible.
AUX OUT
SDI output of the selected SDI, ST2022, or ST2110 input:
•
For Quad Link inputs (4K or 8K) the AUX OUT is link 1.
•
ST2110-20/30 inputs are supported.
1. Audio output is a 1/8-inch (3.5 mm) diameter port for a headset. It has connections for left and
right audio channels. Headset plugs that are 1/8 inch and have an additional contact for a
microphone may not work because the headphone ports are not set for the spacing
requirements of a third connection on the plug.
2. When connecting to an external monitor, a monitor with a 1920×1080 capable display works
best with the instrument.
Descriptions of labeled PRISM MPS-300 rear-panel connectors
Connector label,
symbol, or end Description
