Eye
III+
Video Recording Transmitter
I
nstallation Guide
Page 27
System Configuration and Installation
RJ-45 Network Cable
It is a shielded, straight-through RJ-45 network cable. The cable will
connect the
VRB
to the switch of the
LAN
for typical application.
Software
Transmitter Configuration software
A PC with Transmitter Configuration program installed (included in
the CD-ROM WRS3-AD software).
Information
Valid IP address for the transmitter.
Administrator Password for the transmitter (The default
administrator password is “000000”. You can change it in the
reception software)
Port number for the transmitter (default value is 1024)
Your network subnet mask
Transmitter Configuration
After you prepared all the things discussed in previous section, you should be ready to
configure the transmitter. Note that you have to do so by following the steps discussed
below before you install and use the
VRB
Eye
III
+
Video Recording Transmitter
Serial Cable
