Eye
III+
Video Recording Transmitter
I
nstallation Guide
Page 34
System Configuration and Installation
RJ-45 Network Cable
It is a shielded, straight-through RJ-45 network cable. The cable will
connect the
VRB
to the switch of the
LAN
for typical application.
Crossover Network Cable
Used to connect between the router and PC or the transmitter
Software
Transmitter Configuration software
A PC with Transmitter Configuration program installed (included in
the CD-ROM WRS3-AD software).
Information
Valid IP address for the transmitter.
Router IP address (Please refer to your router menu)
Administrator Password for the transmitter (The default
administrator password is “000000”. You can change it in the
reception software)
Port number for the transmitter (default value is 1024)
Your network gateway address (if you are not familiar with this, you
can use one suggested in later section)
Your network subnet mask (if you are not familiar with this, you can
use one suggested in later section)
2 DNS addresses (you can get them from the Internet Service
Provider)
