Eye
III+
Video Recording Transmitter
I
nstallation Guide
Page 43
System Configuration and Installation
Transmitter Configuration
After you prepared all the things discussed in previous section, you should be ready to
configure the transmitter. Note that you have to do so by following the steps discussed
below before you install and use the
VRB.
Step 1:
Connect a shielded, straight-through 9-to-9 serial cable from the serial port of the
computer to the
AUX
port of the
VRB
.
Step 2:
Turn on the
VRB
. A blue light at the front panel will flash continuously if it is
successfully turned on.
Step 3:
Install the
Eye
III+
Reception Software
(WRS3-AD)
from the CD-
ROM to the computer.
Step 4:
After installation, from
Start menu, select
Program Files
Eye
III+
Transmitter
Configuration
to run the
Configuration
program.
Then, the Configuration
program should appear
as shown:
Eye
III+
VRB
Serial Cable
