background image

Summary of Contents for RV-200

Page 1: ...ustable wrench spanner 7 Marine grade sealant non acetate based 8 Adhesive tape Warning Transducer operation Only test and operate the transducer in the water Do NOT operate out of water as overheating may occur II Warning Marine grade sealant Only use marine grade neutral cure polyurethane sealants Do NOT use sealants containing acetate or silicone which can cause damage to plastic pans Caution T...

Page 2: ...nd shaft s 3 Planing hull Stepped hull mount on the first step as far aft as possible 4 Dis place ment hull Displacement hull mount approximately 1 3 of the way along the lenqth of the hull measured along the waterline Step 2 Rib 3 Row of rivets 4 Strake Item Description 1 Direction to vessel bow 2 Element angle and vessel side 1 12 2o port P starboard S Single all in one transducers are marked Ve...

Page 3: ...ing a sultable sized wrench spanner ln order to prevent leaks and transducer movement ensure that the nut is adequately tightened You shou d see the sealant protruding from the edges of all applied surfaces lmportant Do NOT overtighten Overtightening can cause damage to the hull which may result in water leakinq into the vessel o rA ffi D V 27 From inside the vessel slide the small bronze washer o...

Page 4: ...sducer installations it may be necessary to extend the transducer cable 3 m 9 8 ft 5 m 16 4 ft and 8 m 26 2 ft transducer extension cables are available part numbers 3 m 480475 5 m 480476 8 m A8O477 lt is recommended that a maximum of two cable extensions are used with the total cable length not exceeding 24 m Cable ferrite installation Your product is supplied with a cable ferrite To ensure EMC C...

Reviews: