Eye
III+
Video Recording Transmitter
I
nstallation Guide
Page 24
System Configuration and Installation
Transmitter Installation
Step 1:
Plug the telephone cable into the modem's LINE connector.
Step 2:
Plug the other end into the telephone wall jack.
Step 3:
Plug the modem power cable into the modem power connector.
Step 4:
Connect the modem’s rear panel to the modem port in the rear panel of
VRB
using
a 9 pin- 9 pin serial cable. Tighten the retaining screws to ensure proper
connection.
Step 5:
Use a BNC cable to connect the
VIDEO OUTPUT
of the
CCD
camera and VIDEO
INPUT of the
VRB
(
CH1
is preferred). If more than one camera are installed, plug
the
BNC
cables to the
VRB
CH2
to
CH4/8/16
sequentially.
Step 6:
Connect alarm sensor to the corresponding pins of the
ALARM & SWITCH
port, if
necessary. (For the pin assignment of the
ALARM
port, please refer to section 2,
Alarm Definition).
Step 7:
Plug the modem power supply into a wall let and power on the modem.
Step 8:
Plug the round end of the A.C. adaptor into the socket marked POWER on the
VRB
. (Please use the 12V D.C. power adaptor supplied by
Eye
Group only)
Eye
III+
Video Recording Transmitter
Serial Cable
Modem
Telephone
Cable
Public
Telephone
Network
Support 4 Video
Sources
BNC Cable
