Eye
III+
Video Recording Transmitter
I
nstallation Guide
Page 50
System Configuration and Installation
Step 1:
Plug an RJ-45 network cable into the socket on the switch’s rear panel. Afterwards,
plug the other end into the socket on the
VRB’
s rear panel.
Step 2:
Plug an RJ-45 network cable into the socket on the switch’s rear panel. Afterwards,
plug the other end of the network cable into the socket on the PC 's rear panel.
Step 3:
Plug the ADSL modem power cable into the power connector. At the same time,
plug the ADSL modem power supply into a wall let and power on the modem.
Step 4:
Plug one end of the
BNC
cable into the
VIDEO OUTPUT
of the
CCD
camera, then
plug the other end to the
VRB
's
VIDEO INPUT
connector (
CH1
preferred). If more
than one camera, plug the
BNC
cable to the
VRB
CH2
to
CH4/CH8/CH16
sequentially.
Step 5:
Connect alarm sensor to the corresponding pins of the
ALARM & SWITCH
port, if
necessary (For the pin assignment of the ALARM port, please refer to section 2,
Alarm Definition
).
Step 6:
Plug the round end of the A.C. adaptor into the socket marked
POWER
on the
VRB
.
(Please use the 12VDC power adaptor supplied by
Eye
Group only.)
Step 7:
Plug the A.C. adapter to A.C. power source to power on the
VRB
. The
VRB
's LED
on the front Panel and the
LINK
LED on the rear panel should light up.
Step 8:
You may now use the
VRB
to connect to the transmitter. For the instructions of
using the software, please refer to the
Eye
III+
Reception Software
User
Guide.
