Eye
III+
Video Recording Transmitter
I
nstallation Guide
Page 40
System Configuration and Installation
Transmitter Installation
Step 1:
Plug an RJ-45 network cable into the socket on the router’s rear panel labeled
“
LAN
”. Afterwards, plug the other end of the network cable into the socket on the
VRB
's rear panel.
Step 2:
Plug a router power cable into the router power connector. At the same time, plug
the router power supply into a wall let and power on the router.
Step 3:
Plug an RJ-45 network cable into the socket on the router’s rear panel labeled
“
WAN
”. Afterwards, plug the other end of the network cable into the socket on the
ADSL modem's rear panel.
Step 4:
Plug the ADSL modem power cable into the power connector. At the same time,
plug the ADSL modem power supply into a wall let and power on the modem.
Step 5:
Plug one end of the
BNC
cable into the
VIDEO OUTPUT
of the
CCD
camera, then
plug the other end to the
VRB
's
VIDEO INPUT
connector (
CH1
preferred). If more
than one camera are installed, plug the
BNC
cables to the
VRB
CH2
to
CH4CH8/CH16
sequentially.
Step 6:
Connect alarm sensor to the corresponding pins of the
ALARM & SWITCH
port, if
necessary (For the pin assignment of the ALARM port, please refer to section 2,
Alarm Definition
).
Step 7:
Plug the round end of the A.C. adaptor into the socket marked
POWER
on the
VRB
.
(Note: please use the 12V D.C. power adaptor supplied by
Eye
Group only)
Step 8:
Plug the A.C. adapter to A.C. power source to power on the
VRB
. The
VRB
's LED
on the front Panel and the
LINK
LED on the rear panel should light up.
Step 9:
You may now use the
Eye
III+
Reception Software
to connect to the
transmitter. For the instructions of using the software, please refer to the
Eye
III+
Reception Software
User Guide.
ADSL Modem
To WAN (Dynamic IP)
Router
VRT
Support
4/8/16 video
sources
Eye
III+VRB
