Telecommunications Techniques Corporation interceptor 147, Reference Manual, Page: 93 / 280

3-51
3
INTERCEPTOR 147 2 Mbit/s and Data Analyzer
Setup Categories
If the Start time that was specified (in the Start item) is
later (relative to the time the histogram buffer was turned
on) than the current time, and the histogram buffer is off,
the display shows the following message.
Start Time Must Be
<= Elapsed Time
To clear this error message, set Start to 00:00:00 and Len
to AUTO.
If the Print Buffer is full (100%), the display shows the
following message.
No Memory For
Print Request
When you receive this message, you must clear sufficient
space in the Print Buffer (by printing one or more of the
waiting Prints or by clearing the Print Buffer) before you
can send histogram information to the Print Buffer.
3.6.19 Start
Use the Start item to specify the start time (relative to the
time the histogram buffer was originally turned on) for the
Histogram Print. Specify the start time in the DD/HH:MM
(day/hour:minute) format.
NOTE: A complete specification of the time to be covered
in the Histogram Print requires both the Start and
Len times. It is often useful on the first Histogram
Print to set Start to 00/00:00 and Len to AUTO to
get a Print of the entire histogram buffer contents.
Then, from that Print, you can determine if you
want to use different Start and Len settings to
“zoom in” on particular time periods. (For
complete information, see the section on
Histogram Prints.)