Telecommunications Techniques Corporation interceptor 147, Reference Manual, Page: 134 / 280

Remote Control
6-6
6
INTERCEPTOR 147 2 Mbit/s and Data Analyzer
*ESE [<mask> | ?]
Event Status Enable command/query
The *ESE command sets the Standard Event Status Enable
Register bits. The value of the bits in the Standard Event
Status Enable Register determines which bits in that
register are enabled. When a bit of the Standard Event
Status Register and its corresponding enable bit are set, the
Event Status bit 5 (ESB) of the Status Byte Register is also
set.
The *ESE? query requests the current contents of the
enable register. When the Standard Event Status Register
is read, the value returned is the bit weights of all the set
bits at the time the byte was read.
The act of reading the Standard Event Status Enable
Register sets Bit 5 of the Status Byte Register.
The bits in the Standard Event Status Enable Register
include:
Bit 0 Operation Complete
Bit 1 Request Control
Bit 2 Query Error
Bit 3 Device Dependent Error
Bit 4 Execution Error
Bit 5 Command Error
Bit 6 User Request
Bit 7 Power On
For additional information, see the *ESR and *STB
commands, and refer to Appendix B.
Example:
>*
ESE32
Enables bit 5 (Command Error) of the
Standard Event Status Enable Register.
>*
ESE?
Reads back the Standard Event Status
Enable Register.
32