Telecommunications Techniques Corporation interceptor 147, Reference Manual, Page: 86 / 280

3
Setup Categories
3-44
INTERCEPTOR 147 2 Mbit/s and Data Analyzer
3.6.9 Time Interval
Use the Time Interval item to set the amount of time
between automatic timed Prints. To change the time
interval, move the cursor to the time displayed, and press
SELECT until the desired time interval is displayed. The
time interval is displayed in an HH:MM (hours:minutes)
format.
NOTE: Setting Time Interval to 00:00 disables Timed
Prints.
3.6.10 Event
Use the Event item to specify which event types will cause
an Event Print to be created.
The format of the Event item is:
Event SIGNAL ON
More than one selection can be set to ON at the same time.
Setting all of the selections to OFF, in effect, disables
Event Prints. The following event types can be selected.
SIGNAL (ON/OFF)
When Event is set to SIGNAL ON, any of the following
signal events will trigger an Event Print: Signal Loss,
Signal Present, Clock Loss, Clock Present, HDB3
Lost, HDB3 Present, Code Errors, Frequency Drift
(that is,
∆
ppm worse than
±
50).
FRAME (ON/OFF)
When Event is set to FRAME ON, any of the
following frame events will trigger an Event Print:
FAS Sync Loss, FAS Sync Present, MFAS Sync
Loss, MFAS Sync Present, CRC Multiframe Sync,
CRC Multiframe Sync Lost, FAS Errors, CRC Errors,
MFAS Errors.