Telecommunications Techniques Corporation interceptor 147, Reference Manual, Page: 92 / 280

3
Setup Categories
3-50
INTERCEPTOR 147 2 Mbit/s and Data Analyzer
3.6.18 Hist Print?
To create a histogram and send it to the Print Buffer, move
the cursor to the Hist Print? item and press SELECT. The
histogram is created and placed in the Print Buffer for
printing when a printer is attached and ready.
After you request that a histogram be created, you may get
one of several messages (shown below with their
explanations).
While the INTERCEPTOR 147 prepares the histogram
data, the display shows the following message.
Processing Histogram
Data - Please Wait
If no information regarding the specified result (as selected
in the Hist Rslt item) has accumulated in the histogram
buffer, the display shows the following message.
No Such Event During
Specified Time
If the histogram has been prepared and placed in the Print
Buffer to be printed out, but the printer is not ready, the
display shows the following message.
HISTOGRAM PRINT
PRINTS PENDING: #
PRINT BUFFER xx% FULL
where # is the number of Prints that are in the Print Buffer,
and xx% indicates how full the Print Buffer is.
If the Start time that was specified (in the Start item) is
later (relative to the time the histogram buffer was turned
on) than the current time, and the histogram buffer is on,
the display shows the following message.
Start Time Must Be
<= Stored Time