Telecommunications Techniques Corporation interceptor 147, Reference Manual, Page: 133 / 280

6-5
6
Remote Control
INTERCEPTOR 147 2 Mbit/s and Data Analyzer
The following conventions are used in the representation
of the commands/queries presented in this section.
< > Substitute the appropriate value (in the
indicated format, as appropriate).
[x|y|z] You must type x, or y, or z.
[?] You may type ?, as desired.
NOTE: When an underscore (_) or quotation marks (“ “)
are shown in the command, you must include
them when you type the command.
6.3.2 Common Commands and Queries
The standard IEEE 488.2 commands and queries are listed
alphabetically in this section. These commands all begin
with an asterisk. Information that is entered using the
remote controller is shown in
this bold typeface .
Where useful, an explanation and example are included.
Additionally, for the RES: queries, short forms of the
query are shown and “Not Ready Values” (NRV) are
indicated, as applicable. (The NRV is the response that is
provided when you type in a query and the result is not yet
available. When the result becomes available, it appears
on the monitor without the need for you to repeat the
command.)
*CLS
Clear Status command only