Application Examples
The oscilloscope displays a Lissajous pattern representing the input and
output characteristics of the circuit.
11.
Turn the
Vertical Scale
and
Vertical Position
knobs to optimize the display.
12.
Push
Persist
►
In
fi
nite
.
As you adjust the ambient temperature, the display persistence captures the
changes in the characteristics of the circuit.
Data Logging (non-EDU models only)
You can use the oscilloscope to record data from a source over time. You can
con
fi
gure the trigger conditions and direct the oscilloscope to save all the triggered
waveform together with timing information over a de
fi
ned time duration to a
USB memory device.
The USB host port on the front panel supports data logging. You can set up the
oscilloscope to save user- speci
fi
ed triggered waveforms to a USB device for up
to 24 hours. You can also select the "In
fi
nite" option for continuous waveform
monitoring. In the in
fi
nite mode you can save your triggered waveforms to an
external USB memory device without a duration limitation until the memory
device is full. The oscilloscope will then guide you to insert another USB memory
device to continue saving waveforms.
1.
Con
fi
gure the oscilloscope to use the desired trigger conditions to collect the
data. Also, insert a USB memory device in the front-panel USB port.
2.
Push the front-panel
Function
button.
3.
Select
Data Logging
from the resulting side menu to bring up the data
logging menu.
4.
Push the
Source
button to select the signal source to log data from. You can
use either one of the input channels or the Math waveform.
5.
Push the
Duration
button and turn and push the
Multipurpose
knob to select
the duration for data logging. The selections range from 0.5 hour to 8 hours in
30 minute increments and from 8 hours to 24 hours in 60 minute increments.
You can select
In
fi
nite
to run data logging with no set time limit.
6.
Push the
Select Folder
button to de
fi
ne where to store the collected
information. The resulting menu choices will let you either select an existing
folder or de
fi
ne a new folder. When done, push
Back
to return to the main
data logging menu
7.
Start the data acquisition, such as by pushing either the front-panel
Single
or
Run/Stop
button.
8.
Push
Data Logging
from the side menu to select
On
. This enables the data
logging feature. Before turning on the data logging feature, you must
fi
rst
w w w . e k t
2
. c o m
Electronics
Katrangi
Trading
