Tektronix 070-8462-03, Instruction Manual

Page: 113 / 271

Performance Verification
5–2
1735 HD High Definition Waveform Monitor
Table 5–1: Recommended equipment list (Cont.)
Description Example Requirements
Voltmeter Range: 0 to greater than 100 VDC.
Accuracy:
±
0.1%.
Tektronix DM501A in a TM500 Series Power
Module.
Video Amplitude Calibrator Signal: adjustable square wave 0.0 mV to
999.9 mV p-p with a resolution of 0.1 mV.
Accuracy:
±
0.05%.
Frequency: approximately 270 Hz.
Tektronix 067–0916–00 in a TM500 Series
Power Module.
Peak-to-Peak Detector Amplifier Tektronix Part Number 015–0408–00
(includes one 015–0413–00 Peak-to-Peak
Detector Head), installed in a Tektronix
TM500 Series Power Module.
Power Module For powering up and housing SG503,
DM501A, 067–0916–00, and 015–0408–00. Tektronix TM506 Power Module.
Variable Autotransformer General Radio Metered Auto Transformer
W10MT3W. If 220 V operation must be
checked, a conversion transformer or
appropriate 220 V autotransformer is needed.
Spectrum Analyzer With a Tracking Generator. Tektronix 2712 Spectrum Analyzer.
Auxiliary Equipment and Accessories
Return Loss Bridge For use with the spectrum analyzer. Wide Band Engineering Company RF Bridge
model A57T.
75
W
Precision High Frequency
End-Line Termination
0.25% DC accuracy, with return loss of 42 dB
or greater up to 30 MHz. (For use with the
Return Loss Bridge.) Wide Band Engineering Company precision
fixed terminator model A56T75B.
Sine-Squared Pulse Filter Having a 7-pole Thomson filter. Allen Avionics Sine-Squared Pulse and Bar
Network model 4249.
75
W
End-Line Terminations
(at least seven are needed)
75
W
end-line termination Tektronix Part No. 011–0102–00.
75
W
Feed-Through Termination
(two are needed)
Tektronix Part No. 011–0055–01.
Dual Input Coupler Matched BNC cable-T. Matched length of the
two arms within
±
0.1 inch.
Tektronix Part No. 067–0525–02.
50-to-75
W
Minimum Loss Attenuator
(two are needed)
Tektronix Part No. 011–0057–00.
75
W
Coaxial Cables
(at least four are needed)
42-inch, with male BNC connectors. Tektronix Part No. 012–0074–00.
50
W
Precision Coaxial Cable
(two are needed)
42-inch, with male BNC connectors. Tektronix Part No. 012–0482–00.
50
W
Cable to Square Pin Jumper
Adapter
Make an adapter which consists of a BNC
barrel connector, a BNC male connector, a
short length (six inches) of 50
W
coaxial
cable, and a two-pin square pin jumper.