Tektronix 070-8462-03, Instruction Manual

Page: 26 / 271

1735 HD High Definition Waveform Monitor
1–5
Installation
The shipping carton and pads provide protection for the instrument during
transit, and should be retained in case subsequent shipment becomes necessary.
Repackaging instructions are located in the Maintenance section.
Electrical Installation
This instrument is designed to operate from a single-phase power source having
one of its current-carrying conductors at or near earth-ground (the neutral
conductor). Only the Line conductor is fused for over-current protection.
Systems that have both current-carrying conductors live with respect to ground
(such as phase-to-phase in multiphase systems) are not recommended as power
sources.
The 1735 HD operates over a frequency range of 48 to 66 Hz, over the range of
90 to 250 V, without operator adjustment.
The 1735 HD provides operating flexibility through internal jumper selections,
which are shown in Table 1–1. If any of these jumpers are placed in the optional
position, be sure that all personnel are aware of the changes.
Table 1–1: Internal jumper selection
Jumper Name Jumper Function
A3A1 J100 Light
b e
1–2
{
Lights Enabled
Enable
2–3 Lights Disabled
A3 J6 RGB/YRGB 1–2
{
3 Step
2–3 4 Step
A3 J5 RGB Staircase / EXT
r r
1–2 Inverted Polarity
Horizontal Polarity
2–3
{
Normal Polarity
A4 J2 Remote Sync
r
1–2
{
Rising Edge Trigger
Polarity
2–3 Falling Edge Trigger
{
Factory preset condition.
Power Source
Mains Frequency and
Voltage Ranges
Operating Options