Tektronix 070-8462-03, Instruction Manual

Page: 43 / 271

Operating Basics
2–6
1735 HD High Definition Waveform Monitor
14 LINE display is accessed by holding the LINE SELECT ON button until
there is recognition. In TWO FIELD mode, the 14 lines are intensified in the
display. In ONE or TWO LINE, the 14 lines are overlaid and the readout, if
enabled, gives the number of the first displayed line, followed by a bracketed
14. For example: ‘ 525 [14] ’. A momentary push of the FIELD button
determines whether the displayed lines are from field one, field two, or both
fields (ALL: appears on the readout).
Push and hold both the UP and DOWN buttons to display a predefined line.
NOTE . Lines displayed in LINE SELECT mode have their active video intensified
on the PIX MON OUT signal.
17. FIELD / MENU
In this documentation, the FIELD/MENU button is referred to as the FIELD
button when describing its use to select fields, and the MENU button when
describing menu uses.
Push this three-way toggle button to choose field one, field two, or both
fields (ALL) in LINE SELECT ON mode of operation. When ALL is
selected, the readout displays ‘ALL:’ followed by the selected line number
for field one.
Push and hold this button to enter the menu. An on-screen menu display
provides diagnostics, line rate selection, calibrator, clamp setting, filter
selection, and enabling for External Horizontal, CH1B subtract, or front-
panel offsets. The menu is exited by a momentary push of the MENU button.
18. UP
This momentary push button increases the selected line number. When
readout is enabled (push and hold the MAG / READOUT button), the CRT
readout identifies the selected line.
19. DOWN
This momentary push button decreases the selected line number. When
readout is enabled (push and hold the MAG / READOUT button), the CRT
readout identifies the selected line.
Push and hold both the UP and DOWN buttons to display a predefined line.
20. INTENSITY
Use this control to adjust waveform display brightness.
Display