Tektronix 070-8462-03, Instruction Manual

Page: 54 / 271

Operating Basics
1735 HD High Definition Waveform Monitor
2–17
Figure 2–8: 2 Line color bar display
7. Using the Menu
a. Instrument configurations such as clamp type, filter type, and lines/frame
are made through the menu. Once a setting is made through the menu, it
will remain in effect until altered by entering the menu again.
b. Enter the menu by pushing and holding the LINE SELECT FIELD/
MENU button, as shown in Figure 2–2 on page 2–7. (For simplicity,
this button is referred to as the MENU button while describing menus.)
c. Move the caret to the desired function using the UP or DOWN button,
then push the MENU button. A submenu will appear.
d. Use the UP or DOWN button to position the caret as desired, then push
the MENU button once. In most cases, the desired setting or enable will
become effective, and the main menu will be displayed, then the MENU
button is pushed again to exit the menu entirely. CALIBRATION and
TEST are exceptions. CALIBRATION is described in step 8 of this
procedure, and TEST is described in the preceding section called
“FRONT PANEL DIAGNOSTICS.”
e. When TEST is selected, the submenu presents a choice of tests, each of
which may have a submenu to enable. More information regarding these
tests is located in the preceding section called “FRONT PANEL
DIAGNOSTICS.”