TechniSat DigiCorder T1, Operating Manual

Page: 54 / 61

12 Troubleshooting guide
54
P Prro ob blle em m P Po os ss siib blle e c ca au us se e S So ollu uttiio on n
Various programmes not shown in
programme list Wrong programme list selected Select different programme list (see
Point 7.2.3.1)
Sound OK, no TV picture Reception set to Radio mode Switch to TV mode
Clock time not shown in standby
mode Clock time has not been acquired Switch reception to ZDF or other
major programme to acquire time
Unit controls cannot be operated Defective data flow-->unit blocked Disconnect mains plug for approx. 5
seconds, then switch unit on again
Remote control not working Batteries empty Change batteries
Temporary appearance of small
square blocks in picture, unit
temporarily freezes picture, no
sound. Screen temporarily black
with message “no signal”. Antenna not correctly adjusted Adjust antenna position
No picture, no sound,
display active Defective or missing cable
connection Check all cable connections
Antenna incorrectly adjusted Adjust antenna
No reception when using an active
antenna Antenna feed (5V) not switched on Switch on antenna feed as per Point
6.2.4
No picture, no sound,
display not active No mains power Check mains power cord and plug
No reception of programmes
previously received Antenna maladjusted or faulty Check antenna
Programme now broadcast on
another transponder Perform scan (see Point 8.3)
Programme no longer being
broadcast None
Recording on hard drive no longer
possible Hard drive is full Delete existing recording(s)
Receiver cannot be switched on, or
cannot be operated Receiver blocked Perform flash reset; Note! All perso-
nal settings will be lost.
>
disconnect from mains power.
> Press down stand-by and
Programme UP keys on the
receiver simultaneously, and
keep them depressed.
> While holding down Standby
and Programme Up keys,
reconnect unit to mains power.
> Keep keys pressed down for
approx. 5 seconds until display
"FLAS” appears.
Deleting hard drive recordings not
possible File system of hard drive is dama-
ged Check hard drive (Point 7.15.3.3)