TechniSat DigiCorder T1, Operating Manual

Page: 37 / 61

At the time of going to press for this manual, the complete
range of functions in this menu was not yet finalised, it is the-
refore not possible to to go into more detail in this regard. An
updated version of this manual, reflecting the current func-
tions, can be downloaded at a later stage from the Internet,
at
www.technisat.de.
8.3.2 Hard drive information
> Press OK to display a window showing information on
the integrated hard drive.
8.3.3 Hard drive management
> Press OK to display an overview of the number of
recordings made, and of the free space available.
(Fig. 8-6)
Monitoring the hard drive
> To monitor the hard drive, use the left/right arrow
keys to mark the field Check.
> Press OK , then confirm the screen prompt displayed
by pressing OK again to start the checking procedure.
The status of the hard drive will now be chec-
ked, the result will be displayed on screen.
Formating the hard drive
When the hard drive is formatted, the data system is repla-
ced. This may become necessary if checking the hard drive
reveals faults or problems.
Note!
The hard drive contents are deleted completely
during formating, all existing recordings will be
lost.
> To format the hard drive, use the left/right arrow
keys to mark the field Format.
> Press OK and confirm the following screen prompt by
pressing OK again in order to start the formating pro-
cedure.
Please note !
The receiver may be operated only with the built-in hard
drive. Any other drive may damage the unit.
You should therefore not open the unit case, and replace-
ment of the hard drive would invalidate all terms of the gua-
rantee.
8.4 Sleep timer
> Press the Sleep timer key repeatedly to set the
switch-off time of the receiver from 30 minutes to 2
hours in 30 minute steps.
When the set time has elapsed the receiver will auto-
matically switch to standby mode.
37
(Fig. 8-6)