TAYO ZONTES 310T-M 2022, Maintenance Manual

Page: 160 / 188

160 / 188
assembly. Grasp the balance block and pull it out while
shaking it up and down, left and right. Use the same method
to pull out the left balance weight, soak in hot water for
about 10 minutes before using Blow the dust gun into the
gap between the left hand handle and the direction handle
tube according to the arrow, then pull the direction handle
and the left hand handle in the opposite direction, and then
take out the left hand handle rubber case.
Right:
Left:
3. Installation of the direction component
a. Apply 263 thread fastening glue to the inner wall of the
rubber sleeve in the left hand, and the length of the glue is
1/3 of the rubber sleeve of the handle, and then put the
rubber in the left hand into the direction handle; the inner
wall of the rubber sleeve in the right hand does not need to
be coated with the thread fastening glue. Just load it. Be
careful not to remove the throttle cable on the rubber sleeve
with your right hand. Reinstall the left and right balance
weights according to the disassembly steps, and tighten the
M6×80 bolt with a 5# inner hexagon.
b. When installing the left and right handle switches, you
need to align the cross screrws with the positioning holes ⑥
and then tighten them with a cross screw. Use a 5# inner
hexagon to tighten the other bolts.
c. When installing the auxiliary handle switch, align the
joint surface of the auxiliary handle switch and the main
pump of the disc brake with the triangle mark on the handle
switch, and then tighten the 4 M6×30 bolts with a 5# inner
hexagon.
d. Snap the upper brackets ⑦ , ⑧ , and ⑨ into the lower
part of the direction control cover, buckle the pressure block,
tighten 4 M8×35 bolts with 6# inner hexagon, and use 5#
inner hexagon to fix 1 non-standard M6 Tighten the ×16 bolt
⑶ , be careful not to miss the bushing ⑸ and cushion rubber
⑹ ; then use a 5# inner hexagon to install a non-standard
M6×16 bolt ⑶ + spring washer ⑷ to fix the mobile phone
bracket installation bracket.
4. Installation of the direction handle cover
a. When installing the upper cover in the direction, first
install the upper cover in the appropriate position, first
buckle the buckles a, b, and c on the front of the upper cover
in the direction, and then buckle the back buckles ③ , ④ , ⑤
and The buckles ① and ② on both sides should be fastened.
After installation, the upper cover should be tightly fitted
with the lower cover, and the gap should be even. Finally,
tighten the 2 self-tapping screws at the lower cover (1) with a
flat-head screwdriver.
b. Finally, put the direction back on the middle cover.
●Attention should be pai d when disassembling the direction
handle cover to prevent damage to the buckle.
●After installation, check whether the throttle cable is
assembled in place and whether the return position is
flexible.
●Self -tapping screws need to be installed vertically and the
torque cannot be too large.
●After installation, check the switch buttons of the left and
right handle switches and the left and right auxiliary handle
switches to check whether they can be used normally, and
check whether there is a pressure line.