TAYO ZONTES 310T-M 2022, Maintenance Manual

Page: 168 / 188

168 / 188
11. Disassemble the engine of the vehicle
Caution:
●The vehicle must be parked on a level and stable ground or
on a lifting platform.
●The operation can only be performed after the engine has
cooled down completely.
●Do not press the brake handle after removing the rear
brake caliper.
●Attention and sequence when removing the plastic buckle
to avoid the buckle from breaking
●Wear waterproof gloves whe n draining coolant to prevent it
from getting on your skin.
●The storage box of subsequent production models has been
changed. For disassembly and assembly, please refer to the
chapter "Disassembly of the storage box" in "Disassembly of
Vehicle Covers".
●T he M125 steps are similar to the M310, taking the M310 as
an example.
1. Disassemble the storage box
a. Push the whole car to a wide, flat place, lay down the
main bracket, and unlock the cushion lock.
b. Use a 4# socket head to remove the 2 M6×16 bolts next
to the battery. Open the black protective cover of the
negative terminal of the battery, and use a Phillips
screwdriver to remove the negative bolt of the battery. Then
lift off the red protective cover of the positive pole of the
battery, use a Phillips screwdriver to remove the positive
pole of the battery, take out the positive and negative wires
of the battery, and then screw back the bolts on the battery
with a Phillips screwdriver. Straighten out the cables after
pulling up the 3 fuse boxes.
c. Use a 4# socket head to remove the 2 M6×14 shoulder
bolts next to the battery. Remove the 2 expansion nails on
both sides. After removing the decorative buckle at the rear,
use a 4# hexagon socket to remove 2 M6×16 bolts.
d. Lift the glove box slightly until the ambient light
connector is exposed on the left side of the glove box, unplug
the connector and take out the entire glove box.
e. After removing the starter relay from the battery
compartment, remove the electrical box assembly.
2. Remove the cover
a. Remove 7 pcs decorative glues on the rear armrest, use
4# inner hexagon to remove 2 M6×12 bolt on the front,
remove the 2 swell nails on the rear armrest, use 12# sleeve
Remove the 5 pcs M8×25 bolts. Remove the rear armrest.
b. After putting down the right rear pedal, use a 4# inner
hexagon to remove 1 M6×14 bolt on the peda.