172
/
188
b. One person holds the whole car and slightly lifts the rear
part of the frame, and one person rotates the two rear shock
absorbers to the frame installation groove, and then rotates
the right shock absorber until it is aligned with the frame
installation hole. Pass one M10×1.5×55 bolt, use one M10
nut on the left side to tighten, torque: 30N.m (3.1 kgf.m, 22
lbf.ft). When installing the left side shock absorber, you need
to slightly shake the frame from side to side until the shock
absorber installation hole is aligned with the frame
installation point, and then use the same method to fix the
left side shock absorber.
c. open the brake pads on the rear brake caliper with a flat-
blade or other suitable tool, then install the brake caliper on
the rear rocker arm, and then install 2 M8×37 bolts
⑹
, use
14# set Tighten the barrel, torque: 24N.m (2.4 kgf.m, 18
lbf.ft); then connect the wheel speed sensor plug back to the
corresponding position, install a M6×12 bolt
⑸
, use 4# inner
hexagon to tighten ; Finally, install all the pipes connecting
the brake calipers and the wheel speed sensor into the
corresponding clamps, and arrange the lines.
d. Insert the high-voltage package at the front of the
engine back, and install one M12 nut back on the cradle to fix
the engine, use 17# torx wrench to fix M12 nut, another
person uses 15# socket to tighten bolt, torque: 65N.m (6.5
kgf.m, 48 lbf.ft).
e. Install the rear pedal on the right side of the vehicle to a
suitable position, install two M8×25 bolts, and tighten them
with a 14# sleeve; connect the small water tank inlet pipe to
the corresponding pipeline, and tighten it with a single batch
Clamp; then connect the engine water inlet pipe back to the
corresponding pipe, and use the water clamp clamp to fix the
clamp to the appropriate position to prevent leakage of
coolant.
f. Reconnect the plugs of the stepper motor and the three-
in-one sensor on the throttle valve body; reconnect the
connectors of the high-pressure fuel pipe, fuel injector,
oxygen sensor, crankshaft position sensor, magneto stator
charging cable, and cylinder head water temperature sensor;
Reconnect the negative and positive wires connected to the
starter motor and tighten the bolts; install the two tubes that
connect the carbon canister to the throttle valve body and
the oil-air separator to the air filter.
g. Refer to "Adding Coolant to the Main Water Tank" to
add an appropriate amount of coolant.
Summary of Contents for ZONTES 310T-M 2022
