TAYO ZONTES 310T-M 2022, Maintenance Manual

Page: 134 / 188

134 / 188
M125
1- Secondary water tank 2-Secondary water tank link pipe 3-Engine inlet pipe 4- Thermostat outlet pipe 5- Thermostat 6- Water
tank inlet pipe 7- Water and oil shared sensor 8- Water tank outlet pipe 9- Water tank filling port 10- Radiator assembly 11-
Water pump cover assembly
Cooling system:
Small loop (indicated by the blue arrow):
Cylinder → thermostat → Water tank inlet → water tank → Water tank outlet pipe → Engine inlet pipe → water pump cover
Big loop (indicated by the green arrow):
Cylinder → thermostat → Thermostat outlet pipe → Engine inlet pipe → water pump cover
Cooling system disassembly
Caution:
●Before disassembling, please refer to the steps of
discharging the cooling liquid in the cooling system section of
the "Maintenance" chapter to drain all the cooling liquid
first.
●Wear protective measures such as waterproof gloves and
protective glasses during disassembly, and prevent the
coolant from contacting the skin.
●The disassembly operation must be performed after the
engine, radiator, and muffler are completely cooled.
M310 Remove the radiator assembly
a. Use 4# inner hexagon to remove M6
×
16 bolt
⑴
, water
pipe limit bracket ⑵ will not be removed temporarily. Use a
10# sleeve to remove the M6
×
12 bolt ⑶ , and separate the
water pipe fixing bracket ⑷ from the limit bracket ⑵ .
b. Place the oil pan underneath, clamp the hoop
⑹
with
hoop pliers and move it about 40mm (1.6 in) in the direction
of the arrow. Wear waterproof gloves with both hands and
separate the engine water inlet pipe from the tee joint. Use a
flat-blade screwdriver to loosen the clamp
⑸
and move it
about 40mm (1.6 in) in the direction of the arrow, and
separate the inlet pipe of the small water tank from the
thermostat. Use an oil pan to receive the coolant that may
remain in the pipe.