TAYO ZONTES 310T-M 2022, Maintenance Manual

Page: 60 / 188

60 / 188
a. Use 4# inner hexagon to remove the upper 2 M6
×
14
bolts.
Remove the swell nail. For instructions on disassembly and
assembly of swell nails, please refer to the pre-service
instructions in this chapter.
Grasp the upper part of the storage box with one hand,
and remove the bottom M6
×
16 bolt with the 4# inner
hexagon with the other hand.
b. Remove the right storage box assembly from the car.
c. Open the cover of the Coolant expansion tank, and add
coolant to the Coolant expansion tank with the help of a
funnel, paying attention to adding a small amount to
between "H" and "L" several times.
3. M310 add coolant to the Radiator
a. Refer to the above steps to remove the right storage
box assembly.
b. Unscrew the Radiator filler cap indicated by the arrow.
c. Use a 10# sleeve to loosen the thermostat bleed bolt (5)
counterclockwise by 4 to 5 turns, do not completely remove
it. Note that a small container is required to receive the
coolant overflowing from the exhaust bolt. Do not allow the
coolant to drip directly onto the surface of the part.
d. Put on waterproof gloves and add coolant to the water
inlet of the Radiator with the help of an extended funnel.
Until the position of the vent bolt of the thermostat is stably
overflowed with coolant, the coolant level can be seen at the
water filling port.
e. Tighten the filler cap of the Radiator. Tighten the
exhaust bolt ⑸ ; torque: 8
～
10N.m (0.8
～
1 kgf.m, 6
～
7
lbf.ft).
4. Put coolant
M310
a. Place an oil pan underneath, wear waterproof gloves
and use a 10# sleeve to remove the drain bolt ⑹ and O ring
⑺ .
b. Remove the filler cap of the Radiator to accelerate the
flow of coolant.
c. Wipe all the joint surfaces clean with a non-woven cloth.
Check whether the bolt ⑹ joint surfaces are scratched, if
any, replace them with new ones. The O ring ⑺ needs to be
replaced every time it is disassembled.
d. Put the new O-ring ⑺ into the bolt ⑹ first, taking care
not to scratch the O-ring. Torque of bolt
⑹
: 8
～
10N.m (0.8
～
1 kgf.m, 6
～
7 lbf.ft).
M125
a.
抓牢水箱罩后
用
4#
内六角拆下
3
颗
M6×14
螺栓后取
下。