TAYO ZONTES 310T-M 2022, Maintenance Manual

Page: 51 / 188

51 / 188
Remove the M6×16 bolts(3) on both sides with a 4# inner
hexagon.
i. According to this step for folding rear storage box, and
the monolithic rear storage box skip directly to the next step.
Use your fingers or a plastic crowbar to pry the glove box
rubber strip
⑺
from one end and remove it. Remove the
decorative buckle ⑻ of the M6 hexagon socket bolt; remove
the M6×16 bolts ⑶ on both sides with 4# hex socket, remove
the bushing ⑷ and the cushion rubber ⑸ . Remove the 3
M4×16 bolts ⑼ with a Phillips screwdriver.
j. Remove the decorative buckle ⑻ of the M6 hexagon
socket bolt; remove the M6×16 bolts ⑶ on both sides with
4# hex socket.
k. Grasp the tail skirt of the storage box and pull it upward
obliquely, paying attention to the cables in the battery
compartment. Pull up to see the left side of the glove box
atmosphere lamp thread, unplug the thread and remove the
glove box assembly.
l. Unplug the plug of the stepping motor ① .
m. Use a short Phillips screwdriver to remove the 2
GB9074.4 M4×12 bolts ③ and the anti-off card ④ that come
with the throttle valve body assembly, and then remove the
stepping motor
⑽ .
n. Use throttle cleaner to clean the carbon deposits on the
head of the stepper motor. Spray a small amount of cleaning
agent into the valve body hole. It is forbidden to soak the
stepper motor with any liquid.
o. Install the stepper motor back to the valve body, paying
attention not to miss the sealing ring. Plug the plug back in.
3. Remove the throttle valve body assembly to
clean up carbon deposits
a. Unplug the plugs of the stepping motor ① and the
three-in-one sensor ② .