TAYO ZONTES 310T-M 2022, Maintenance Manual

Page: 90 / 188

90 / 188
h. After replacing the four valve adjusting gaskets, check
and confirm the four valve gaps again. If there is a deviation
from the standard, repeat step ⑥ and ⑦ to adjust again
until it meets the standard range.
i.Set the two valve rocker arm limit blocks on the M5×15-
5# hexagon socket head bolts, and then apply a proper
amount of thread locker on the threads of the M5×15-5#
hexagon socket head bolts. Install the two valve rocker arm
limit blocks together with M5×15-5# hexagon socket head
bolts on the intake valve rocker arm shaft and the exhaust
valve rocker arm shaft, and the tightening torque value is
5±1N.m (0.5 ±0.1 kgf.m, 4±0.7 lbf.ft).
j. Wipe off the oil and residual sealant on the joint surface
of the cylinder head and the seal ring of the cylinder head
with a clean rag, and reapply a proper amount of sealing
silicone on the corners of the joint surface of the cylinder
head. Then install the cylinder head cover assembly
corresponding to the shape of the joint surface. Use 8#T-
shaped socket wrench (or wind batch) to lock the cylinder
head cover 6 M6×30 hexagon flange bolts, the torque value is
10±2N.m(1±0.2 kgf.m,7.4±1.5 lbf.ft) ).
k. Put the 13×2.8 O-ring on the M14×1.5 screw plug, screw
it into the corresponding screw hole of the right crankcase
cover, and tighten it with a 5# Allen key. The torque value is
10±2N.m(1±0.2 kgf.m, 7.4±1.5 lbf.ft); After putting the
27.4×2.65 O-ring on the M30×1.5 aluminum screw plug,
screw it into the corresponding screw hole of the right
crankcase cover, tighten it with a 10# Allen key, the torque
value is 16±2N.m (1.6±0.2 kgf.m, 12±1.5 lbf.ft).