TAYO ZONTES 310T-M 2022, Maintenance Manual

Page: 103 / 188

103 / 188
3. Error code
Code Instruction Code Instruction
P0030
The heating control circuit of the upstream 1
cylinder oxygen sensor is open
PD116
Engine coolant temperature sensor signal is
unreasonable
P0031
The upstream 1 cylinder oxygen sensor
heating control circuit voltage is too low
P0117
Engine coolant temperature sensor circuit voltage is
too low
P0032
The upstream 1 cylinder oxygen sensor
heating control circuit voltage is too high
P0118
Engine coolant temperature sensor circuit voltage is
too high
P0106
The intake pressure sensor/atmospheric
pressure sensor is unreasonable
P0122 Throttle position sensor circuit voltage ultra-low limit
P0107 Intake pressure sensor is shorted to ground P0123 Throttle position sensor circuit voltage limit
P0108
The intake air pressure sensor is shorted to
the power supply
P0130
The signal of the upstream 1 cylinder oxygen sensor is
unreasonable
P0112
Intake air temperature sensor signal voltage
is too low
P0131
The signal of the upstream 1 cylinder oxygen sensor is
too low
P0113
Intake air temperature sensor signal voltage
is too high
P0132
The signal circuit voltage of the upstream 1 cylinder
oxygen sensor is too high
P0134
Upstream 1 cylinder oxygen sensor circuit
signal failure
P0627 Oil pump relay control circuit is open
P0201 1 cylinder injector control circuit is open P0629
The oil pump relay control circuit is shorted to the
power supply
P0261
1 cylinder injector control circuit is shorted to
ground
P0650 MIL lamp driver stage circuit failure
P0262
The 1 cylinder injector control circuit is
shorted to the power supply
P0444 Canister solenoid valve open
P0322
No speed sensor pulse signal (open circuit or
short circuit)
P0459 Canister solenoid valve is shorted to the power supply
P0480 Fan control circuit is open P0458 Canister solenoid valve is shorted to ground
P0691 Fan control circuit is shorted to ground P2300 1 cylinder ignition coil is shorted to ground
P0692
The fan control circuit is shorted to the
power supply
P0628 The oil pump relay control circuit voltage is too low
P0511 Idle speed actuator control circuit is open P1098 Dump sensor signal voltage is too low
P0563 System battery voltage is too high P1099 Dump sensor signal voltage is too high
4. Clear fault code
After troubleshooting the EFI, it needs to be cleared manually or through a diagnostic tool. M310 can be cleared manually,
M125 need to use the ISO15765-4 communication protocol (CAN diagnosis) diagnostic instrument to clear.
4.1 M310 manually clear
a. Unlock the vehicle
b. Turn off the flame switch to "";
c. Start the vehicle, refuel in neutral gear to more than 4000 rpm and hold for 10 seconds;
d. Release the throttle, turn the flameout switch to "", and be careful not to power off the whole vehicle, and wait for more
than 10 seconds;
e. After repeating the above three steps for 4 times, the fault light goes out.
4.2 Use the diagnostic tool to clear
The steps of different brands or models may be different, so please refer to the description of the diagnostic Speedometer
manual to clear the fault code.
●When the engine is running, the fault light does not turn on, and the fault light flashes after the engine is turned off, it is a
historical fault, which will not affect the performance and life of the whole vehicle, and will automatically disappear later.