31
SDA³ / SDA³ E - Rev.04 - Mar / 22
6. Set-up instructions
Preparing the equipment
The equipment must always be parked on a dry and flat place, free from any debris or
strange objects. Follow this procedure to set the equipment up:Clean up to remove strange
objects from the equipment and from the working area;
1. Make sure that there is enough room to maneuver the tractor until it hitches to the
equipment;
2. Turn on the tractor and slowly approach it to the hitching point direction;
3. Use a clean cloth or a paper towel to clean the couplers in the end of the hoses. Also,
clean the area around the tractor couplers;
4.
Activate the clutch to turn on/off the activation system of the equipment;
5.
Check if the fertilizer tubes are properly fixed;
6. Check the functioning of the seed hoppers and observe if the singulator is free to
move, since the equipment paintwork may block it. If the singulator is blocked, scrape
the paint excess to let it free;
7.
Check the tires inflation and keep the pressure as stated on the 'tires inflation' page;
8.
Lubricate all grease fittings appropriately (see the 'lubrication' page in the 'maintenance'
section).
