55
PMT - Rev. 05 - Sep/22
Corn head maintenance
1. Wash the whole equipment using only water; remove crop residues and then let the
equipment dry completely on the sun for approximately a day. After that, lubricate
the equipment and start moving it to remove all the humidity of the moving parts;
2. Repair the damaged paintwork to avoid rust;
3. After 24 hours of service, the tightening of the equipment bolts must be checked. To
assure a better performance and avoid unnecessary wear and ruptures, retighten
these bolts;
4. Check the moving parts of the equipment for wear occurence. If necessary, replace
them to let the equipment ready for the next harvest;
5. Spray the whole equipment using preservative oil. Never use burnt oil;
6. The transmission chains must be removed when the harvest is over, cleaned and
stored in a container with lubricant oil until the next harvest;
7. Clean and lubricate all grease fittings;
8. After all the repairs and all the maintenance steps, store the equipment in a covered
and dry place, protected from the sun and rain;
9. Before starting the job, turn the equipment on for a few minutes, activate the PTO
rotation and check if there are any noises. If so, do not work before detecting such
noises and fixing them;
10. Replace the missing or damaged safety decals. Marchesan supplies these decals,
upon request and indication of their respective serial numbers. The operator must
know the need and importance to keep the decals in the proper place and in good
conditions. The operator also have to know the need to follow the instructions, as
the lack of safety may increase the risk of accidents.
9. Maintenance
NOTE
- Use TATU original parts only.
Summary of Contents for PMT
Page 1: ...OPERATOR S MANUAL PMT PMT...
Page 60: ...58 PMT Rev 05 Sep 22 11 Notes...
Page 62: ...www marchesan com br...
